- ago
I'm running WL7 Build 27 with TrendChartStyles build 4.

I open 3 charts, all with symbol SPY, and set them to streaming (IQFeed). Then I configure the 3 charts, all to point and figure with the following settings:

Chart1
Timeframe = 30min
Calculation = High Low
Box Type = Fixed
BoxSize = 1
Reversal Count = 1

Chart2
Timeframe = 5min
Calculation = High Low
Box Type = Fixed
BoxSize = 0.5
Reversal Count = 1

Chart3
Timeframe = 1min
Calculation = High Low
Box Type = Fixed
BoxSize = 0.2
Reversal Count = 1

Then I wait and when a new bar arrives and the charts redraw, then the Point and Figure BoxSize setting for a chart (sometimes 30min, sometimes 5min) changes from its original value to the value from the 1 min chart.

Then if I manually change the chart back to its proper value however then the point and figure x and o's get rendered completely incorrectly.
Do you see this issue also?
Thanks for the support
0
48
3 Answers

Reply

Bookmark

Sort
- ago
#1
Thanks, will take a look at this tomorrow.
1
- ago
#2
We have this resolved now for B28, keep an eye out for the release, it will likely be a little while because the new Symbol by Symbol Optimization is part of B28.
1
- ago
#3
Awesome. B28 is great. I think I'm nearly at the end of my conversion from WL6 to WL7. Just performance issues that I need to address. Thanks for the great support.
1

Reply

Bookmark

Sort